MirrorNest
← Todos os guias

WLED

Free, open-source firmware for controlling individually-addressable LED strips from an ESP8266/ESP32 board, with a huge library of effects, presets, and integrations (including Home Assistant).

Destino: ESP8266 / ESP32 microcontroller (flashed from a computer, then runs standalone)LED-stripsESP32firmwareSite oficial ↗Documentação oficial ↗
Este guia foi elaborado a partir da documentação oficial do WLED, ligada acima — verifique sempre lá os nomes exatos dos pacotes/versões antes de executar estes comandos num servidor de produção, uma vez que as versões da distribuição e do projeto mudam com o tempo.

  1. 1Flash WLED to your board

    The official web installer flashes over USB directly from Chrome/Edge -- no separate flashing software needed.

    WLED web installer ↗

  2. 2Connect the board to Wi-Fi

    On first boot, WLED creates its own 'WLED-AP' access point -- connect to it and enter your home Wi-Fi credentials in the captive portal that opens.

    Wire the LED data line to the correct GPIO pin for your board (documented per board on the WLED site) and make sure the LED strip's power supply is rated for its full length -- undersized power is the most common source of flickering or dim LEDs.

  3. 3Open the WLED web UI

    Once on your network, WLED serves its own control interface directly from the board's IP address -- effects, colors, presets, and scheduling, no app or cloud account required.

    WLED + Home Assistant integration ↗